Extron electronic P/2 DA 2 WM/EC, APP P/2 DA2 WM wallmount installation, Setting the DIP switches

Controls and Installation, cont’d

P/2 DA2 WM wallmount installation

Once the input and output cables have been connected and the P/2 DA2 WM has been successfully tested, the faceplate may be attached to the mounting bracket using the 4 supplied screws. See figure 2-8.

The center pole of the power input connector contains no conductor. Connect the conductors to the two outer poles only, exactly as shown here.

Positive

N/C

Negative

Audio (3.5mm	Power (3.5mm
Captive Screw
	Captive Screw
Connector)
	Connector)

AUTO	POWER
AUDIO

100%
UNITY	INPUT
50%
GAIN/PEAKING	BUFFERED

LOCAL	ID	PIN 4
	ID
	MONITOR	PIN	11

P/2 DA2 WM

VGA Connector

Figure 2-8 — Wall mounting the P/2 DA2 WM

P/2 DA2 EC Euro Channel installation

Once the input and output cables have been connected and tested on the P/2 DA2 EC, the distribution amplifier can be easily installed in the Euro Channel. See figure 2-9.

WM

P/2DA2

PINS

ID4 11

POWER			ADSP
			TM
AUTO	AUDIO	MONITOR WITH
		BUFFERED
		LOCAL
GAIN/		INPUT
PEAKING
100%50%
UNITY

WM

P/2DA2

PINS

ID4 11

	POWER				ADSP
					TM
	AUTO		AUDIO	MONITOR WITH
				BUFFERED
Euro Channel				LOCAL
	GAIN/PEAKING			INPUT
			50%
		100%
	UNITY

Figure 2-9 — Euro Channel installation

Setting the DIP switches

Two sliding-type DIP switches can be found on the faceplate of the P/2 DA2 WM/EC.

1 2 To set the sliding-type DIP switches, slide the

switch to the on/closed or off/open position.

The two DIP switches provide proper ID bit termination for a laptop computer that is not attached to a local monitor.

ID PIN 4 & ID PIN 11

ON — Set both pins to On if you are using the

ID PIN 4

ID PIN 11P/2 DA2 WM/EC with a laptop computer that is not attached to a local monitor.

2-10 P/2 DA2 WM/EC Controls and Installation P/2 DA2 WM/EC Controls and Installation 2-11