Extron electronic P/N 68-412-02 Connecting System 4xi to Hughes/JVC Projectors, Config, Prj Cable

Hughes Installation Configuration and Connections

Connecting System 4xi to Hughes/JVC Projectors

[System 4model andsoftware

versiondisplayed here]

(See note.)

(See note.)

(See note.)

(See note.)

(Note: Information depends on System 4 setup.)

If the System 4xi is already configured for a Hughes/JVC projector, go to step 4. If it is not set up correctly, it will be necessary to change switch settings on the System 4xi ’s Main Controller Board. Begin at Step 1 to verify the correct configuration.

1.Use the Front Panel to display the Information Menu to verify that the System 4xi is already set up for the Hughes/JVC projector. Apply power to the System 4xi and do the following:

a.Press to display the MENU SELECT on the LCD screen.

b.Press or to step to Menu 8.

}	c. Press		to select this menu.
	d. Press	or to display the configuration. The example to the left is general,
	yours will show the System 4xi model name, the software version and the
	following information:
	PRJ = HUGHES
	PRJ BAUD = 19200

UNIT No.= 000

HST BAUD = 9600 (value depends upon setup Menu 3)

2.Go to the procedure on page 2-3 to remove the System 4xi cover and then go to page 2-4 to set up the Main Controller board. Return to Step 3 (below) when the configuration is correct.

Config	Projector	SW1: 1-2-3-4	SW2	SW3	SW4	SW5	SW6	Prj Cable	Comm
as									Adapter
✔	Hughes-JVC	off-on-off-on	0	0	5	6	0	J15	26-467-01

SW3

SW2

SW4

SW5

J15

SW1

4 3 2 1

ON

3.Double-check your work and be sure the System 4xi cover is on securely.

4.Install the System 4xi in its place of operation (i.e. rack), but do not connect the power cable.

__________ Changes in some switch configurations are not detected until the power is

removed at the AC cord, and then restored.

Follow the correct cable connection diagram for your Hughes projector and continue the installation.

5.The UNV ADP, “A” (26-467-01) has two 9-pin connectors, one male and one female. Plug the 9-pin female connector onto the 9-pin male marked “Control Out” (Port B) on the Hughes projector back panel.

Extron • System 4xi Switcher Series • User’s Manual • P/N 68-412-02 Rev. A Page 1