Installation and Operation, cont’d
approximately 30 feet (9.14 meters) within 40 degrees on either side of the axis. See the following illustration.
VOLUME |
| PROJECTOR |
| |
| PROJECTOR | PROJECTOR | FUNCTION | |
| ON |
| OFF | BUTTON |
IR | LIGHTS |
| LIGHTS | PC |
ON |
| OFF | ||
INPUT | INPUT | INPUT | INPUT | INPUT |
1 | 2 | 3 | 4 | 5 |
Extron
SCP 150 L
40
40
30feet maximum
IR 402 Remote
6Volume knob and indicator LEDs — Turn this knob to adjust the volume on the input that is currently selected. The five LEDs indicate the current volume level, as shown in the following illustration. The top LED is red and the others are green.
VOLUME | VOLUME | VOLUME |
LED Off |
|
|
LED Blinking |
|
|
LED On |
|
|
0% (Min) or Mute | ||
VOLUME | VOLUME | VOLUME |
7AAP mounting spaces (SCP 150 AAP only) — Mount up to four
Resetting to Factory Firmware version
To reset the SCP to the firmware version with which it was delivered from the factory, press and hold the buttons numbered 1 and 3 on the front panel while applying power to the unit. See the following three illustrations.
VOLUME | PROJECTOR |
| IR |
| SCP 150 |
To reset, press these two buttons simultaneously while applying power to the SCP 150.
Resetting the SCP 150 to factory defaults
VOLUME | PROJECTOR |
| IR |
| SCP 150 AAP |
To reset, press these two buttons simultaneously while applying power to the SCP 150 AAP.
Resetting the SCP 150 AAP to factory defaults
| SCP 150 • Installation and Operation |
