F845 | F853 | |
|
| |
Communications Option (DeviceNet/Profibus) Setting 12 | Direct Access Number — F845 | |
Program ⇒ Communications ⇒ Communication Settings | Parameter Type — Selection List | |
Same as F841. See F841 for information on this parameter | Factory Default — 0000h | |
Changeable During Run — Yes | ||
| ||
|
| |
Communications Option (DeviceNet/Profibus) Setting 13 | Direct Access Number — F846 | |
Program ⇒ Communications ⇒ Communication Settings | Parameter Type — Selection List | |
Same as F841. See F841 for information on this parameter | Factory Default — 0000h | |
Changeable During Run — Yes | ||
| ||
|
| |
Disconnection Detection Extended Time | Direct Access Number — F850 | |
Program ⇒ Communications ⇒ Communication Settings | Parameter Type — Numerical | |
This parameter is used to set the length of time that no communications activity | Factory Default — 0.0 | |
Changeable During Run — Yes | ||
may exist before the communications link is disconnected. | ||
| ||
| Minimum — 0.0 | |
| Maximum — 100.0 | |
| Units — Seconds | |
|
| |
ASD Operation at Disconnect | Direct Access Number — F851 | |
Program ⇒ Communications ⇒ Communication Settings | Parameter Type — Selection List | |
This parameter is used to set the H9 ASD action to be carried out in the event of | Factory Default — Stop, | |
Communication Release | ||
the loss of communications. | Changeable During Run — Yes | |
| ||
Settings: |
| |
0 — Stop and Terminate Communication |
| |
1 — Do Nothing (continue programmed operation) |
| |
2 — Deceleration Stop |
| |
3 — Coast Stop |
| |
4 — Emergency Off |
| |
5 — Preset Speed (setting of F852) |
| |
|
| |
Preset Speed Operation Selection | Direct Access Number — F852 | |
Program ⇒ Communications ⇒ Communication Settings | Parameter Type — Selection List | |
This parameter is used in conjunction with parameter F806. | Factory Default — 0 (Disabled) | |
Changeable During Run — Yes | ||
| ||
This parameter setting is used to set the Preset Speed selection to be used if |
| |
Preset Speed is selected at parameter F851. |
| |
Settings: |
| |
0 — Disabled |
| |
1 – 15 — Preset Speed Number |
| |
|
| |
Communications Option Station Address Monitor | Direct Access Number — F853 | |
Program ⇒ Communications ⇒ Communication Settings | Parameter Type — Selection List | |
This parameter is used in the setup of the communications network by reading | Factory Default — 0 (Disabled) | |
Changeable During Run — Yes | ||
the Media Access Code (MAC) address of the ASD that is connected to a node | ||
| ||
of the communications system. | Minimum — 0 | |
The MAC Address is set via DIP switches of the optional device. | Maximum — 255 | |
| ||
See the DeviceNet Option Instruction Manual (P/N 58683) for more |
| |
information on this parameter. |
|
212 | H9 ASD Installation and Operation Manual |