F902 |
| F905 | |
|
|
| |
Input Function Target 2 | Direct Access Number — | F902 | |
Program ⇒ My Function ⇒ My Function Unit 1 | Parameter Type — Selection List | ||
This parameter plays a role in the setup of the My Function feature by | Factory Default — 0 (Disabled) | ||
Changeable During Run — Yes | |||
selecting the functionality of the programmable Input Function Target 2 | |||
|
| ||
terminal. |
|
| |
This setting assigns the function of the programmable Input Function Target 2 |
|
| |
terminal to any one of the |
|
| |
Table 8 on pg. 241, or Table 10 on pg. 243. |
|
| |
See F977 for more information on this parameter. |
|
| |
|
|
| |
Input Function Command 2 | Direct Access Number — | F903 | |
Program ⇒ My Function ⇒ My Function Unit 1 | Parameter Type — Selection List | ||
This parameter is used to assign a | Factory Default — 0 (NOP) |
| |
|
| ||
selected Input Function Target variables, enable a counter/timer function, or |
|
| |
perform a hold/reset function. |
|
| |
Table 11 on pg. 245 lists the available selections. Their use and selection |
|
| |
requirements are described in an example at F977. |
|
| |
|
|
| |
Input Function Target 3 | Direct Access Number — | F904 | |
Program ⇒ My Function ⇒ My Function Unit 1 | Parameter Type — Selection List | ||
This parameter plays a role in the setup of the My Function feature by | Factory Default — 0 (Disabled) | ||
Changeable During Run — Yes | |||
selecting the functionality of the programmable Input Function Target 3 | |||
|
| ||
terminal. |
|
| |
This setting assigns the function of the programmable Input Function Target 3 |
|
| |
terminal to any one of the |
|
| |
Table 8 on pg. 241, or Table 10 on pg. 243. |
|
| |
See F977 for more information on this parameter. |
|
| |
|
|
| |
Output Function Assigned | Direct Access Number — | F905 | |
Program ⇒ My Function ⇒ My Function Unit 1 | Parameter Type — Selection List | ||
| Factory Default — 0 (Disabled) |
This parameter plays a role in the setup of the My Function feature by
selecting the functionality of the Output Function Assigned terminal.
Changeable During Run — Yes
This setting assigns the function of the programmable Output Function Assigned data location to one of the functions listed in the Input Setting field of Table 7 on pg. 240.
Settings:
0 – 3099
See the My Function Instruction Manual (P/N 58692) and F977 for more information on this parameter.
216 | H9 ASD Installation and Operation Manual |