F875 | F877 | ||
|
| ||
Block Read Data 1 | Direct Access Number — F875 | ||
Program ⇒ Communications ⇒ Communication Settings | Parameter Type — Selection List | ||
This parameter plays a role in the setup of the communications network by | Factory Default — 0 (None) | ||
Changeable During Run — Yes | |||
establishing the type of data to be read from the ASD using the communications | |||
| |||
link. |
| ||
The communications network includes other ASDs and Host/Control computers |
| ||
that monitor the status of the ASD(s), transfers commands, and loads or |
| ||
modifies the parameter settings of the ASD. |
| ||
Changes made to this parameter require that the power be cycled (Off then On) |
| ||
for the changes to take effect. |
| ||
Settings: |
| ||
0 | — None |
| |
1 | — Status Information |
| |
2 | — Output Frequency |
| |
3 | — Output Current |
| |
4 | — Output Voltage |
| |
5 | — Alarm Information |
| |
6 | — PID Feedback Value |
| |
7 | — Input Terminal Status |
| |
8 | — Output Terminal Status |
| |
9 | — V/I |
| |
10 — RR |
| ||
11 — RX |
| ||
12 — DC Voltage |
| ||
13 — PG Feedback |
| ||
14 — Torque |
| ||
15 — My Monitor 1 |
| ||
16 — My Monitor 2 |
| ||
17 — My Monitor 3 |
| ||
18 — My Monitor 4 |
| ||
19 — Free Memo |
| ||
|
| ||
Block Read Data 2 | Direct Access Number — F876 | ||
Program ⇒ Communications ⇒ Communication Settings | Parameter Type — Selection List | ||
This parameter plays a role in the setup of the communications network by | Factory Default — None | ||
Changeable During Run — Yes | |||
establishing the type of data to be read from the ASD of the communications | |||
| |||
link. |
| ||
See parameter F875 for more information on this setting. |
| ||
|
| ||
Block Read Data 3 | Direct Access Number — F877 | ||
Program ⇒ Communications ⇒ Communication Settings | Parameter Type — Selection List | ||
|
| Factory Default — None |
This parameter plays a role in the setup of the communications network by
Changeable During Run — Yes
establishing the type of data to be read from the ASD of the communications link.
See parameter F875 for more information on this setting.
214 | H9 ASD Installation and Operation Manual |