Toshiba H9 operation manual F515 F521, Pattern Operation Selection, Pattern Operation Mode

F515 F521

Deceleration Time 4

Program ⇒ Special ⇒ Accel/Decel #1 – #4 Settings

This parameter specifies the time in seconds for the output of the ASD to go from the Maximum Frequency to 0.0 Hz for the #4 Deceleration profile. The Accel/Decel pattern may be set using F502. The minimum Accel/Decel time may be set using F508.

Note: A deceleration time shorter than the load will allow may cause nuisance tripping and mechanical stress to loads. Automatic Accel/Decel, Stall, and Ridethrough settings may lengthen the deceleration times.

Direct Access Number — F515

Parameter Type — Numerical

Factory Default — (ASD-dependent)

Changeable During Run — Yes

Minimum — 0.1

Maximum — 6000

Units — Seconds

Acceleration/Deceleration Pattern 4	Direct Access Number —	F516
Program ⇒ Special ⇒ Accel/Decel #1 – #4 Settings	Parameter Type — Selection List
This parameter enables a user-selected preprogrammed output profile that	Factory Default — Linear
	Changeable During Run — Yes
controls the acceleration and deceleration pattern for the #4 Accel/Decel
parameter.
Settings:
0 — Linear
1 — S-Pattern 1
2 — S-Pattern 2
Acceleration/Deceleration Switching Frequency 3	Direct Access Number —	F517
Program ⇒ Special ⇒ Accel/Decel Special	Parameter Type — Numerical
This parameter sets the frequency at which the acceleration control is switched	Factory Default — 0.00
	Changeable During Run — Yes
from the Accel #3 profile to the Accel #4 profile during a multiple-acceleration
profile configuration.	Minimum — 0.00
	Maximum — Max. Freq. (F011)
	Units — Hz
Pattern Operation Selection	Direct Access Number —	F520
Program ⇒ Pattern Run ⇒ Pattern Run	Parameter Type — Selection List
Pattern Run operation is enabled by selecting Seconds or Minutes as a unit of	Factory Default — Disabled
	Changeable During Run — No
measure for the Operation Time setting for the selected Preset Speeds.
See Parameter F523 for more information on Selections and Group Speeds
setup.
Settings:
0 — Disabled
1 — Enabled (units in seconds)
2 — Enabled (units in minutes)
Pattern Operation Mode	Direct Access Number —	F521
Program ⇒ Pattern Run ⇒ Pattern Run	Parameter Type — Selection List
	Factory Default — Reset After Stop

This parameter sets the start condition of subsequent Pattern Runs after the

initial Pattern Run has been terminated or has completed its programming.

Settings:

0 — Reset After Stop

1 — Continue After Stop

Changeable During Run — No

170 H9 ASD Installation and Operation Manual