F125

F131

Input Terminal 15 (LI7) Function

Program Terminal Input Terminals

This parameter is used to set the functionality of the LI7 discrete input terminal.

In addition, this input terminal must be specified as Normally Open or Normally Closed.

This setting assigns the function of the programmable LI7 terminal to any one of the user-selectable functions listed in Table 5 on pg. 236.

Note: The Expansion IO Card Option 2 option board (P/N ETB004Z) is required to use this terminal.

See the Expansion IO Card Option 2 instruction manual (P/N 58686) for more information on the function of this terminal.

Direct Access Number — F125

Parameter Type — Selection List

Factory Default — Unassigned

Changeable During Run — No

Input Terminal 16 (LI8) Function

Program Terminal Input Terminals

This parameter is used to set the functionality of the LI8 discrete input terminal.

In addition, this input terminal must be specified as Normally Open or Normally Closed.

This setting assigns the function of the programmable LI8 terminal to any one of the user-selectable functions listed in Table 5 on pg. 236.

Note: The Expansion IO Card Option 2 option board (P/N ETB004Z) is required to use this terminal.

See the Expansion IO Card Option 2 instruction manual (P/N 58686) for more information on the function of this terminal.

Direct Access Number — F126

Parameter Type — Selection List

Factory Default — Unassigned

Changeable During Run — No

UT1

UT2

Output Terminal 1 (OUT1) Function

Direct Access Number — F130

Program Terminal Output Terminals

Parameter Type — Selection List

This parameter is used to set the functionality of the OUT1 discrete output

Factory Default — Low Speed Signal

Changeable During Run — No

terminals O1A and O1B.

 

The O1A and O1B (OUT1) output terminals change states (open or close) as a

 

function of a user-selected event. See Table 8 on pg. 241 for listing the possible

 

assignments for the OUT1 terminals.

 

In addition, the output terminals must be specified as Normally Open or

 

Normally Closed.

 

See parameter F669 for more information on this setting.

 

 

 

Output Terminal 2 (OUT2) Function

Direct Access Number — F131

Program Terminal Output Terminals

Parameter Type — Selection List

 

Factory Default — RCH (Acc/Dec

This parameter is used to set the functionality of the OUT2 discrete output terminals O2A and O2B.

The O2A and O2B (OUT2) output terminals change states (open or close) as a function of a user-selected event. See Table 8 on pg. 241 for listing the possible assignments for the OUT2 terminals.

In addition, the output terminals must be specified as Normally Open or Normally Closed.

Complete)

Changeable During Run — No

See parameter F669 for more information on this setting.

92

H9 ASD Installation and Operation Manual

Page 100
Image 100
Toshiba H9 F125 F131, Input Terminal 15 LI7 Function, Input Terminal 16 LI8 Function, Output Terminal 1 OUT1 Function