Toshiba H9 operation manual F906 F910

F906		F910
Input Function Target 1	Direct Access Number —	F906
Program ⇒ My Function ⇒ My Function Unit 2	Parameter Type — Selection List
This parameter plays a role in the setup of the My Function feature by	Factory Default — 0 (Disabled)
	Changeable During Run — Yes
selecting the functionality of the programmable Input Function Target 1
terminal.
This setting assigns the function of the programmable Input Function Target 1
terminal to any one of the user-selectable functions listed in Table 7 on pg. 240,
Table 8 on pg. 241, or Table 10 on pg. 243.
See F977 for more information on this parameter.
Input Function Command 1	Direct Access Number —	F907
Program ⇒ My Function ⇒ My Function Unit 2	Parameter Type — Selection List
This parameter is used to assign a user-selected logical operator to two user-	Factory Default — 0 (NOP)
selected Input Function Target variables, enable a counter/timer function, or
perform a hold/reset function.
Table 11 on pg. 245 lists the available selections. Their use and selection
requirements are described in an example at F977.
Input Function Target 2	Direct Access Number —	F908
Program ⇒ My Function ⇒ My Function Unit 2	Parameter Type — Selection List
This parameter plays a role in the setup of the My Function feature by	Factory Default — 0 (Disabled)
	Changeable During Run — Yes
selecting the functionality of the programmable Input Function Target 2
terminal.
This setting assigns the function of the programmable Input Function Target 2
terminal to any one of the user-selectable functions listed in Table 7 on pg. 240,
Table 8 on pg. 241, or Table 10 on pg. 243.
See F977 for more information on this parameter.
Input Function Command 2	Direct Access Number —	F909
Program ⇒ My Function ⇒ My Function Unit 2	Parameter Type — Selection List
This parameter is used to assign a user-selected logical operator to two user-	Factory Default — 0 (NOP)

selected Input Function Target variables, enable a counter/timer function, or perform a hold/reset function.

Table 11 on pg. 245 lists the available selections. Their use and selection requirements are described in an example at F977.

Input Function Target 3

Program ⇒ My Function ⇒ My Function Unit 2

This parameter plays a role in the setup of the My Function feature by selecting the functionality of the programmable Input Function Target 3 terminal.

This setting assigns the function of the programmable Input Function Target 3 terminal to any one of the user-selectable functions listed in Table 7 on pg. 240, Table 8 on pg. 241, or Table 10 on pg. 243.

See F977 for more information on this parameter.

Direct Access Number — F910

Parameter Type — Selection List

Factory Default — 0 (Disabled)

Changeable During Run — Yes

H9 ASD Installation and Operation Manual 217