F964

F966

Analog Function Assigned Object 21

Program My Function My Function Analog

This parameter plays a role in the setup of the My Function feature by selecting the functionality to which the adjustment of F962 is applied.

Settings:

0 — Disabled (None)

1 — Acceleration Rate

2 — Upper Limit Frequency

3 — Acceleration Multiplication Factor

4 — Deceleration Multiplication Factor

5 — Manual Torque Boost

6— Over Current Stall (F601)

7— Thermal Protection

8— Speed Loop P Gain (F460)

9— Drooping Gain (F320)

10— PID P Gain (F362)

Direct Access Number — F964

Parameter Type — Selection List

Factory Default — 0 (Disabled)

Changeable During Run — Yes

See the My Function Instruction Manual (P/N 58692) for a complete description of the setup requirements and operational information of the Analog Function Assigned Object parameter.

Monitor Output Function 11

Program My Function My Function Monitor

This parameter plays a role in the setup of the My Function feature by establishing the function that is to be recorded and output as the Peak, Minimum, or Average value as selected at parameter F966.

Select the Monitor Display Input Setting number from Table 10 on pg. 243 to output the corresponding function.

Use the Communication Number if operating using communications.

See the My Function Instruction Manual (P/N 58692) for a complete description of the setup requirements and operational information of the Monitor Output Function parameter.

Direct Access Number — F965

Parameter Type — Selection List

Factory Default — 2000

Changeable During Run — Yes

Monitor Output Function Command 11

Program My Function My Function Monitor

This parameter plays a role in the setup of the My Function feature by allowing the user to select the Peak, Minimum, or Normal (Avg.) value of the parameter F965 selection to be recorded and output as a monitored function.

Settings:

0 — Normal

1 — Peak

2 — Minimum

Direct Access Number — F966

Parameter Type — Selection List

Factory Default — Normal

Changeable During Run — Yes

See the My Function Instruction Manual (P/N 58692) for a complete description of the setup requirements and operational information of the Monitor Output Function parameter.

H9 ASD Installation and Operation Manual

229

Page 237
Image 237
Toshiba H9 operation manual F964 F966, Monitor Output Function Command