
F854 | F871 | |
|
| |
Communications Option Speed Switch Monitor DeviceNet/ | Direct Access Number — F854 | |
| Parameter Type — Hardware Selectable | |
Program ⇒ Communications ⇒ Communication Settings | Factory Default — | |
This parameter is used in the setup of the communications network by reading | Changeable During Run — No | |
Minimum — 0 | ||
the | ||
If using the DEV002Z Devicenet card, this parameter reads the hardware | Maximum — 255 | |
| ||
switch SW300 setting of the Devicenet card. SW300 sets the baud rate and the |
| |
MAC address of the option card that is connected to a node of the |
| |
communications system. |
| |
See the DeviceNet Option Instruction Manual (P/N 58683) for more |
| |
information on this parameter or see the Instruction manual for the option being |
| |
used with the H9 ASD. |
| |
|
| |
Block Write Data 1 | Direct Access Number — F870 | |
Program ⇒ Communications ⇒ Communication Settings | Parameter Type — Selection List | |
| Factory Default — None |
This parameter plays a role in the setup of the communications network by
Changeable During Run — Yes
establishing the type of data to be written to the ASD of the communications link.
The communications network includes other ASDs and Host/Control computers that monitor the status of the ASD(s), transfers commands, and loads or modifies the parameter settings of the ASD.
Changes made to this parameter require that the power be cycled (Off then On) for the changes to take effect.
Settings:
0 — None
1 — FA00 (command 1)
2 — FA20 (command 2)
3 — FA01 (frequency)
4 — FA50 (TB output)
5 — FA51 (analog output)
Block Write Data 2 | Direct Access Number — F871 | ||
Program ⇒ Communications ⇒ Communication Settings | Parameter Type — Selection List | ||
This parameter plays a role in the setup of the communications network by | Factory Default — None | ||
Changeable During Run — Yes | |||
establishing the type of data to be written to the ASD of the communications | |||
| |||
link. |
| ||
The communications network includes other ASDs and Host/Control computers |
| ||
that monitor the status of the ASD(s), transfers commands, and loads or |
| ||
modifies the parameter settings of the ASD. |
| ||
Changes made to this parameter require that the power be cycled (Off then On) |
| ||
for the changes to take effect. |
| ||
Settings: |
| ||
0 | — None |
| |
1 | — FA00 (command 1) |
| |
2 | — FA20 (command 2) |
| |
3 | — FA01 (frequency) |
| |
4 | — FA50 (TB output) |
| |
5 | — FA51 (analog output) |
|
H9 ASD Installation and Operation Manual | 213 |