Toshiba H9 F878 F901, Free Notes, Network Option Reset Settings, Input Function Target

F878	F901
Block Read Data 4	Direct Access Number — F878
Program ⇒ Communications ⇒ Communication Settings	Parameter Type — Selection List
This parameter plays a role in the setup of the communications network by	Factory Default — None
	Changeable During Run — Yes
establishing the type of data to be read from the ASD of the communications
link.
See parameter F875 for more information on this setting.
Block Read Data 5	Direct Access Number — F879
Program ⇒ Communications ⇒ Communication Settings	Parameter Type — Selection List
This parameter plays a role in the setup of the communications network by	Factory Default — None
	Changeable During Run — Yes
establishing the type of data to be read from the ASD of the communications
link.
See parameter F875 for more information on this setting.
Free Notes	Direct Access Number — F880
Program ⇒ Communications ⇒ Communication Settings	Parameter Type — Numerical
	Factory Default — 0

This is an unused parameter that has allocated memory space.

Changeable During Run — Yes

The space may be used at the discretion of the user.This space may be used to

store information or a note to be transferred using communications.

Minimum — 0

Maximum — 65534

Network Option Reset Settings

Program ⇒ Communications ⇒ Communication Settings

This parameter plays a role in the setup of the communications network by establishing the targets of a Reset command received via the communications link.

Settings:

0 — Reset ASD only

1 — Reset Option Board and ASD

Direct Access Number — F899 Parameter Type — Selection List Factory Default — Reset ASD only Changeable During Run — Yes

Input Function Target 1	Direct Access Number —	F900
Program ⇒ My Function ⇒ My Function Unit 1	Parameter Type — Selection List
This parameter plays a role in the setup of the My Function feature by	Factory Default — 0 (Disabled)
	Changeable During Run — Yes
selecting the functionality of the programmable Input Function Target 1
terminal.
This setting assigns the function of the programmable Input Function Target 1
terminal to any one of the user-selectable functions listed in Table 7 on pg. 240,
Table 8 on pg. 241, or Table 10 on pg. 243.
See F977 for more information on this parameter.
Input Function Command 1	Direct Access Number —	F901
Program ⇒ My Function ⇒ My Function Unit 1	Parameter Type — Selection List

Factory Default — 0 (NOP)

This parameter is used to assign a user-selected logical operator to two user- selected Input Function Target variables, enable a counter/timer function, or perform a hold/reset function.

Table 11 on pg. 245 lists the available selections. Their use and selection requirements are described in an example at F977.

H9 ASD Installation and Operation Manual 215