
F294 | F301 | |
|
| |
Preset Speed 15 | Direct Access Number — F294 | |
Program ⇒ Frequency ⇒ Preset Speeds | Parameter Type — Numerical | |
This parameter assigns an output frequency to binary number 1111 and is | Factory Default — 0.00 | |
Changeable During Run — Yes | ||
identified as Preset Speed #15. The binary number is applied to S1 – S4 of the | ||
Minimum — Lower Limit (F013) | ||
Terminal Board to output the Preset Speed (see F018 for more information on | ||
this parameter). | Maximum — Upper Limit (F012) | |
| ||
| Units — Hz | |
|
| |
PWM Carrier Frequency | Direct Access Number — F300 | |
Program ⇒ Special ⇒ Carrier Frequency | Parameter Type — Numerical | |
This parameter sets the frequency of the pulse width modulation signal applied | Factory Default — 2.200 | |
Changeable During Run — No | ||
to the motor. | ||
| ||
Note: When operating in the Vector Control mode the carrier | Minimum — 1.0 | |
Maximum — | ||
frequency should be set to 2.2 kHz or above. | ||
Units — kHz | ||
|
Note: If the PWM carrier frequency is set at 2.0 kHz or above, it cannot be decreased below 2.0 kHz while running. If the PWM carrier frequency is set at 1.9 kHz or below, it cannot be increased above
2.0kHz while running. Either change requires that the ASD be stopped and restarted for the changes to take effect.
Auto Restart Selection
Program ⇒ Protection ⇒ Retry/Restart
This parameter Enables/Disables the ability of the drive to start into a spinning motor when the ST – CC connection opens momentarily and is then closed (Break/Make ST) or after a power interruption (momentary power failure).
Settings:
0 — Off
1 — Enabled (at Power Failure)
2 — Enabled (at
3 — Enabled (at
Direct Access Number — F301
Parameter Type — Selection List
Factory Default — Off
Changeable During Run — No
H9 ASD Installation and Operation Manual | 133 |