F003 |
| F004 | |
|
|
| |
| Command Mode | Direct Access Number — F003 | |
| Program ⇒ Fundamental ⇒ Standard Mode Selection | Parameter Type — Selection List | |
| The Command Mode Selection establishes the source of the command input | Factory Default — Terminal Block | |
| Changeable During Run — No | ||
| for the ASD. Command inputs include Run, Stop, Forward, etc. The Override | ||
|
| ||
| feature may supersede the Command Mode Selection setting (see Command |
| |
| Mode and Frequency Mode Control on pg. 36). |
| |
| Settings: |
| |
0 | — Terminal Block |
| |
1 | — Not Used |
| |
2 | — EOI Keypad |
| |
3 | — RS485 |
| |
4 | — Communication Option Board |
| |
|
|
| |
| Frequency Mode 1 | Direct Access Number — F004 | |
| Program ⇒ Fundamental ⇒ Standard Mode Selection | Parameter Type — Selection List | |
|
|
| Factory Default — RR |
The Frequency Mode 1 setting establishes the source of the
input for the ASD. The Frequency Mode 2 setting or the Override feature may | Changeable During Run — No |
| |
supersede the Frequency Mode 1 setting (see Command Mode and Frequency |
|
Mode Control on pg. 36 and F200 for more information on this setting). |
|
Note: Only Bolded items from the Settings list below may be placed in the Override mode. See the section titled Command Mode and Frequency Mode Control on pg. 36 for more information on the Override feature.
Settings:
1 — V/I
2 — RR
3 — RX
5 — EOI Keypad
6 — RS485
7 — Communication Option Board
8 — RX2 Option (AI1)
9 — Option V/I
10 — UP/DOWN Frequency
11 — Pulse Input (option)
12 — Pulse Input (motor CPU)
13 — Binary/BCD Input (option)
H9 ASD Installation and Operation Manual | 77 |