Toshiba H9 operation manual F946 F950

F946 F950

Output Function Assigned

Program ⇒ My Function ⇒ My Function Unit 5

This parameter plays a role in the setup of the My Function feature by selecting the functionality of the Output Function Assigned terminal.

This setting assigns the function of the programmable Output Function Assigned data location to one of the functions listed in the Input Setting field of Table 8 on pg. 241.

Settings:

0 – 3099

Direct Access Number — F946

Parameter Type — Selection List

Factory Default — 0 (Disabled)

Changeable During Run — Yes

See the My Function Instruction Manual (P/N 58692) and F977 for more information on this parameter.

Input Function Target 1	Direct Access Number —	F947
Program ⇒ My Function ⇒ My Function Unit 6	Parameter Type — Selection List
This parameter plays a role in the setup of the My Function feature by	Factory Default — 0 (Disabled)
	Changeable During Run — Yes
selecting the functionality of the programmable Input Function Target 1
terminal.
This setting assigns the function of the programmable Input Function Target 1
terminal to any one of the user-selectable functions listed in Table 7 on pg. 240,
Table 8 on pg. 241, or Table 10 on pg. 243.
See F977 for more information on this parameter.
Input Function Command 1	Direct Access Number —	F948
Program ⇒ My Function ⇒ My Function Unit 6	Parameter Type — Selection List
This parameter is used to assign a user-selected logical operator to two user-	Factory Default — 0 (NOP)
selected Input Function Target variables, enable a counter/timer function, or
perform a hold/reset function.
Table 11 on pg. 245 lists the available selections. Their use and selection
requirements are described in an example at F977.
Input Function Target 2	Direct Access Number —	F949
Program ⇒ My Function ⇒ My Function Unit 6	Parameter Type — Selection List
This parameter plays a role in the setup of the My Function feature by	Factory Default — 0 (Disabled)
	Changeable During Run — Yes
selecting the functionality of the programmable Input Function Target 2
terminal.
This setting assigns the function of the programmable Input Function Target 2
terminal to any one of the user-selectable functions listed in Table 7 on pg. 240,
Table 8 on pg. 241, or Table 10 on pg. 243.
See F977 for more information on this parameter.
Input Function Command 2	Direct Access Number —	F950
Program ⇒ My Function ⇒ My Function Unit 6	Parameter Type — Selection List

Factory Default — 0 (NOP)

This parameter is used to assign a user-selected logical operator to two user- selected Input Function Target variables, enable a counter/timer function, or perform a hold/reset function.

Table 11 on pg. 245 lists the available selections. Their use and selection requirements are described in an example at F977.

H9 ASD Installation and Operation Manual 225