F202 |
| F204 | |
|
|
| |
V/I Input Point 1 Frequency | Direct Access Number — | F202 | |
Program ⇒ Frequency ⇒ Speed Reference Setpoints | Parameter Type — Numerical | ||
This parameter is used to set the gain and bias of the V/I input terminal when | Factory Default — 0.00 |
| |
Changeable During Run — Yes | |||
the V/I terminal is used as the control input while operating in the Speed | |||
|
| ||
Control mode. | Minimum — 0.00 |
| |
This parameter sets V/I Input Point 1 Frequency and is the frequency that is | Maximum — Max. Freq. (F011) | ||
associated with the setting of V/I Input Point 1 Setting when operating in the | Units — Hz |
| |
Speed Control mode. |
| ||
|
| ||
See V/I Input Point 1 Setting for more information on this setting. |
|
| |
|
|
| |
V/I Input Point 2 Setting | Direct Access Number — | F203 | |
Program ⇒ Frequency ⇒ Speed Reference Setpoints | Parameter Type — Numerical | ||
This parameter is used to set the gain and bias of the V/I input terminal when | Factory Default — 100 |
| |
Changeable During Run — Yes | |||
the V/I terminal is used as the control input while operating in the Speed | |||
|
| ||
Control mode or the Torque Control mode. | Minimum — 0 |
| |
This parameter sets the V/I input level that is associated with V/I Input Point 2 | Maximum — 100 |
| |
Frequency when operating in the Speed control mode or is associated with the | Units — % |
| |
V/I Input Point 1 Rate when operating in the Torque Control mode. |
| ||
|
| ||
This value is entered as 0% to 100% of the V/I input signal range. |
|
| |
See V/I Input Point 1 Setting for more information on this setting when used |
|
| |
for Speed control. |
|
| |
See V/I Input Point 1 Rate for more information on this setting when used for |
|
| |
Torque Control. |
|
| |
|
|
| |
V/I Input Point 2 Frequency | Direct Access Number — | F204 | |
Program ⇒ Frequency ⇒ Speed Reference Setpoints | Parameter Type — Numerical | ||
This parameter is used to set the gain and bias of the V/I input terminal when | Factory Default — 60.00 |
| |
Changeable During Run — Yes | |||
the V/I terminal is used as the control input while operating in the Speed | |||
|
| ||
Control mode. | Minimum — 0.00 |
| |
This parameter sets V/I Input Point 2 Frequency and is the frequency that is | Maximum — Max. Freq. (F011) | ||
associated with the setting of V/I Input Point 2 Setting when operating in the | Units — Hz |
| |
|
| ||
Speed Control mode.
See V/I Input Point 1 Setting for more information on this setting.
106 | H9 ASD Installation and Operation Manual |
