Toshiba H9 F427 F431, Reverse Speed Limit Input Level, Speed Limit torque=0 Center Value

F427			F431
Reverse Speed Limit Input		Direct Access Number —	F427
Program ⇒ Torque ⇒ Torque Control		Parameter Type — Selection List
This parameter Enables/Disables the Reverse Speed Limit Input control		Factory Default — Disabled
		Changeable During Run — Yes
function. When enabled and operating in the Torque Control mode, the reverse
speed limit is controlled by the terminal selected here. If Setting is selected, the
value set at F428 is used as the Reverse Speed Limit input.
Settings:
0	— Disabled
1	— V/I
2	— RR
3	— RX
4	— Setting (F428)
Reverse Speed Limit Input Level		Direct Access Number —	F428
Program ⇒ Torque ⇒ Torque Control		Parameter Type — Numerical
This parameter provides a value to be used as the Reverse Speed Limit setting		Factory Default — 80.0
		Changeable During Run — Yes
if Setting is selected at F427.
		Minimum — 0.00
		Maximum — Upper Limit (F012)
		Units — Hz
Speed Limit (torque=0) Center Value Reference		Direct Access Number —	F430
Program ⇒ Torque ⇒ Torque Speed Limiting		Parameter Type — Selection List
The system has the ability to limit the amount that the speed may vary as a		Factory Default — Disabled
		Changeable During Run — Yes
function of a changing load while operating in the Torque Control mode. This
parameter sets the input terminal that will be used to control the allowable
speed variance.
Settings:
0	— Disabled
1	— V/I
2	— RR
3	— RX
4	— F431 Setting
Speed Limit (torque=0) Center Value		Direct Access Number —	F431
Program ⇒ Torque ⇒ Torque Speed Limiting		Parameter Type — Numerical
The system has the ability to limit the amount that the speed may vary as a		Factory Default — 0.00
		Changeable During Run — Yes
function of a changing load while operating in the Torque Control mode. This
parameter sets the targeted speed. The plus-or-minus value (range) for this		Minimum — 0.00
setting may be set at F432.		Maximum — Max. Freq. (F011)

Units — Hz

156 H9 ASD Installation and Operation Manual