F402 | F409 | ||
|
|
| |
Autotuning 2 | Direct Access Number — F402 | ||
Program ⇒ Motor ⇒ Vector Motor Model | Parameter Type — Selection List | ||
This parameter introduces a thermal element into the autotuning equation and is | Factory Default — Off | ||
Changeable During Run — No | |||
used to automatically adjust the Autotune parameter values as a function of | |||
|
| ||
increases in the temperature of the motor. |
|
| |
Settings:
0 — Off
1 —
2 — Forced Air Cooled Motor Tuning
Motor Rated Capacity | Direct Access Number — F405 | |
Program ⇒ Motor ⇒ Vector Motor Model | Parameter Type — Numerical | |
This parameter is used to set the (nameplated) rated capacity of the motor being | Factory Default — 11.0 | |
Changeable During Run — Yes | ||
used. | ||
| ||
| Minimum — 0.1 | |
| Maximum — 500.00 | |
| Units — kW |
Motor Rated Current
Program ⇒ Motor ⇒ Vector Motor Model
This parameter is used to set the (nameplated) current rating of the motor being used.
Direct Access Number — F406
Parameter Type — Numerical
Factory Default — 20.3
Changeable During Run — Yes
Minimum — 0.1
Maximum — 2000.0
Units — Amps
Motor Rated RPM | Direct Access Number — F407 | |
Program ⇒ Motor ⇒ Vector Motor Model | Parameter Type — Numerical | |
This parameter is used input the (nameplated) rated speed of the motor. | Factory Default — 1730 | |
Changeable During Run — Yes | ||
| ||
| Minimum — 100 | |
| Maximum — 60000 | |
| Units — RPM |
Base Frequency Voltage 1
Program ⇒ Vector ⇒ Vector Motor Model
The Motor #1 Base Frequency Voltage 1 is the Motor #1 output voltage at the Base Frequency (F014). Regardless of the programmed value, the output voltage cannot be higher than the input voltage.
The actual output voltage will be influenced by the input voltage of the ASD and the Supply Voltage Correction setting (F307).
Direct Access Number — F409
Parameter Type — Numerical
Factory Default —
Changeable During Run — Yes
Minimum — 50.0
Maximum — 660.0
Units — Volts
152 | H9 ASD Installation and Operation Manual |
