
Option V/I Terminal Voltage/Current Selection
Program ⇒ Frequency ⇒ V/I Settings
This parameter is used to set the AI2 input terminal to receive either current or voltage as a control signal.
Note: The Expansion IO Card Option 2 option board (P/N ETB004Z) is required to use this terminal.
Direct Access Number — F109
Parameter Type — Selection List
Factory Default — Voltage Input
Changeable During Run — No
See the Expansion IO Card Option 2 instruction manual (P/N 58686) for more information on the function of this terminal.
Settings:
0 — Voltage Input
1 — Current Input
Always ON 1 Terminal 1
Program ⇒ Terminal ⇒ Input Terminals ⇒ ON
This parameter is used to set the functionality of the virtual discrete input terminal ON. As a virtual terminal, the ON control terminal exists only in memory and is considered to always be in its True (connected to CC) state.
It is often practical to assign a function to this terminal that the user desires to be maintained regardless of external conditions or operations.
This parameter sets the programmable ON terminal to any one of the user- selectable functions listed in Table 5 on pg. 236.
Direct Access Number — F110
Parameter Type — Selection List
Factory Default — Unassigned
Changeable During Run — No
Input Terminal 1 (F) Function
Program ⇒ Terminal ⇒ Input Terminals
This parameter is used to set the functionality of the F discrete input terminal.
In addition, this input terminal must be specified as Normally Open or Normally Closed.
This parameter sets the programmable F terminal to any one of the user- selectable functions listed in Table 5 on pg. 236.
Direct Access Number — F111
Parameter Type — Selection List
Factory
Changeable During Run — No
Input Terminal 2 (R) Function | Direct Access Number — | F112 | |
Program ⇒ Terminal ⇒ Input Terminals | Parameter Type — Selection List | ||
This parameter is used to set the functionality of the R discrete input terminal. | Factory Default — Reverse | Reverse | |
Changeable During Run — No | |||
In addition, this input terminal must be specified as Normally Open or | |||
|
| ||
Normally Closed. |
|
| |
This parameter sets the programmable R terminal to any one of the user- |
|
| |
selectable functions listed in Table 5 on pg. 236. |
|
| |
|
|
| |
Input Terminal 3 (ST) Function | Direct Access Number — | F113 | |
Program ⇒ Terminal ⇒ Input Terminals | Parameter Type — Selection List | ||
| Factory Default — Standby |
|
This parameter is used to set the functionality of the ST discrete input terminal.
In addition, this input terminal must be specified as Normally Open or Normally Closed.
This parameter sets the programmable ST terminal to any one of the user- selectable functions listed in Table 5 on pg. 236.
Changeable During Run — No
88 | H9 ASD Installation and Operation Manual |