
RRR Input Point 1 Setting
Program ⇒ Frequency ⇒ Speed Reference Setpoints
This parameter is used to set the gain and bias of the RR input terminal when the RR terminal is used as the control input while operating in the Speed Control mode or the Torque Control mode.
This parameter sets the RR input level that is associated with the RR Input Point 1 Frequency setting when operating in the Speed control mode or is associated with the RR Input Point 1 Rate setting when operating in the Torque Control mode.
Direct Access Number — F210
Parameter Type — Numerical
Factory Default — 0
Changeable During Run — Yes
Minimum — 0
Maximum — 100
Units — %
Speed Control | Frequency Settings | |
| ||
Perform the following setup to allow the system to perform Speed control from |
| |
the RR input terminal: |
| |
• Set RR Input Point 1 Frequency (F211). |
| |
• Set RR Input Point 1 Setting (F210) — the input analog signal level that |
| |
corresponds to the frequency setting at RR Input Point 1 Frequency. |
| |
• Set RR Input Point 2 Frequency (F213). |
| |
• Set RR Input Point 2 Setting (F212) — the input analog signal level that |
| |
corresponds to the frequency setting at RR Input Point 2 Frequency. |
| |
RR Input Speed Control Setup |
| |
Perform the following setup to allow the system to receive Speed control input |
| |
at the RR input terminal: |
| |
• Program ⇒ Fundamental ⇒ Standard Mode Selection ⇒ Frequency Mode |
| |
1 ⇒ RR. |
| |
• Program ⇒ Fundamental ⇒ Standard Mode Selection ⇒ Command Mode |
| |
Selection ⇒ Terminal Block. |
| |
• Provide a Run command (F and/or R). |
| |
Once set, as the RR input voltage changes, the output frequency of the ASD |
| |
will vary in accordance with the above settings. |
| |
This parameter value is entered as 0% to 100% of the RR input signal range. |
| |
RR Input Point 1 Frequency | Direct Access Number — F211 | |
Program ⇒ Frequency ⇒ Speed Reference Setpoints | Parameter Type — Numerical | |
This parameter is used to set the gain and bias of the RR input terminal when | Factory Default — 0.00 | |
Changeable During Run — Yes | ||
the RR terminal is used as the control input while operating in the Speed | ||
| ||
Control mode. | Minimum — 0.00 | |
This parameter sets RR Input Point 1 Frequency and is the frequency that is | Maximum — Max. Freq. (F011) | |
associated with the setting of RR Input Point 1 Setting when operating in the | Units — Hz | |
Speed Control mode. | ||
| ||
See RR Input Point 1 Setting for more information on this setting. |
|
110 | H9 ASD Installation and Operation Manual |