Toshiba H9 operation manual Trips/Faults, LED Display LCD Display Possible Causes

Trips/Faults

A Trip is a H9 ASD response to a Fault (though, Fault and Trip are sometimes used interchangeably). A Trip is a safety feature that disables the ASD system in the event that a subsystem of the ASD is malfunctioning or a parameter setting has been exceeded.

Listed in Table 14 are the Faults that may result in a Trip and the possible causes. When a Trip is incurred the system displays the Fault screen. The Fault screen identifies the active Fault.

A more user-friendly indication of the active Fault will be displayed at the LCD screen.

			Table 14
LED Display	LCD Display		Possible Causes
E	Emergency Off	•	Emergency Off command received via EOI or remotely.
E-10	Sink/Source Setting	•	Improperly positioned Sink/Source jumper on the Terminal board or on an
			option device (see J100 at the Terminal PCB of the ASD).
	Error
		• Sink/Source configuration is incorrect.
E-11	Brake Sequence	•	F630 is set to a non-zero value.
	Response Error	• Braking sequence discrete input and output terminals are not setup properly.
E-12		•	ASD is configured to receive a signal from a shaft-mounted encoder and no
	Encoder Signal-Loss		signal is being received while running.
	Error	• Disconnection at the Encoder circuit.
		• Motor is stopped and is generating torque via torque limit control.
		• ASD is not configured properly.
E-13		•	Result of a motor speed that is greater than the commanded speed when
	Over Speed		using an encoder for speed control.
		• Improper encoder connection or setup information.
		•	Defective encoder.
E-17	Key Failure	•	Same key input for 20 seconds or more.
E-18	Terminal Input Error	•	V/I signal loss.
		•	Terminal Board failure.
		•	P24 overcurrent condition.
		• F633 setting is too high.
E-19	CPU Communication	•	CPU data Transmit/Receive error.
	Error
E-20	V/f Control Error	•	Torque processing error.
		•	Make service call.
E-21	CPU Processing	•	Software processed incorrectly.
	Error	•	Make service call.
E-22	Logic Input Voltage	•	Incorrect voltage applied to the discrete input terminals.
	Error
E-23	Optional Expansion	•	Optional Expansion Input Terminal Board 1 is defective.
	Input Terminal Board
	1 Error

250 H9 ASD Installation and Operation Manual