F498

F501

Permanent Magnet (PM) Motor Constant 1

Program Motor PM Motor

This parameter is used with synchronous motor applications only.

Contact Toshiba Customer Service Department for information on this parameter.

Direct Access Number — F498

Parameter Type — Numerical

Factory Default — (ASD-dependent)

Changeable During Run — Yes

Minimum — 0

Maximum — 100

Units — %

Permanent Magnet (PM) Motor Constant 2

Program Motor PM Motor

This parameter is used with synchronous motor applications only.

Contact Toshiba Customer Service Department for information on this parameter.

Direct Access Number — F499

Parameter Type — Numerical

Factory Default — (ASD-dependent)

Changeable During Run — Yes

Minimum — 0

Maximum — 100

Units — %

Acceleration Time 2

Program Special Acc/Dec #1 – #4 Settings

This parameter specifies the time in seconds for the output of the ASD to go from 0.0 Hz to the Maximum Frequency for the #2 Acceleration profile. The Accel/Decel pattern may be set using F502. The minimum Accel/Decel time may be set using F508.

This setting is also used to determine the acceleration rate of the UP/DOWN Frequency Functions.

Direct Access Number — F500

Parameter Type — Numerical

Factory Default — (ASD-dependent)

Changeable During Run — Yes

Minimum — 0.1

Maximum — 6000.0

Units — Seconds

Note: An acceleration time shorter than the load will allow may cause nuisance tripping and mechanical stress to loads. Automatic Accel/Decel, Stall, and Ridethrough settings may lengthen the acceleration times.

Deceleration Time 2

Program Fundamental Accel/Decel #1 Settings

This parameter specifies the time in seconds for the output of the ASD to go from the Maximum Frequency to 0.0 Hz for the #2 Deceleration profile. The Accel/Decel pattern may be set using F502. The minimum Accel/Decel time may be set using F508.

This setting is also used to determine the deceleration rate of the UP/DOWN Frequency Functions.

Direct Access Number — F501

Parameter Type — Numerical

Factory Default — (ASD-dependent)

Changeable During Run — Yes

Minimum — 0.1

Maximum — 6000

Units — Seconds

Note: A deceleration time shorter than the load will allow may cause nuisance tripping and mechanical stress to loads. Automatic Accel/Decel, Stall, and Ridethrough settings may lengthen the deceleration times.

164

H9 ASD Installation and Operation Manual

Page 172
Image 172
Toshiba H9 F498 F501, Permanent Magnet PM Motor Constant, Direct Access Number F500, Direct Access Number F501