System Configuration and Menu Options
Root Menus
The Mode key accesses the three primary modes of the H9 ASD: the Frequency Command mode, the Monitor mode, and the Program mode. From either mode, press the Mode key to loop through to the other two modes (see Figure 27). While in the Frequency Command mode, pressing the ESC key toggles the menu to and from the EOI Command mode and the Frequency Command mode.
The Alarm or Fault information will be displayed in the event of an active Alarm or Fault. Alarm text will be displayed on the Frequency Command screen and on the LED screen when active. Fault information will be displayed via the Fault screen. See Alarms and Trips on pg. 246 for more information on Alarms and Trips.
Note: EOI Command mode changes made when accessed via the method shown in Figure 27 are effective for EOI control Only.
Figure 27. H9 ASD Root Menu Navigation.
Frequency Command Mode
Frequency Setting
While operating in the Local mode (Local LED is illuminated on the front panel), the running frequency of the motor may be set from the Frequency Command screen. Using the Rotary Encoder, enter the Frequency Command value, connect ST to CC, and provide a Run command (F and/or R) and then press the Run key. The motor will run at the Frequency Command speed and may be changed while running. See Figure 22. on pg. 31 and Operation (Local) on pg. 73 for more information on the Frequency Command mode.
H9 ASD Installation and Operation Manual | 41 |
