Extron electronic SCP 150L Mounting the SCP, Mounting in a wall box, Mounting in a rack

Installation and Operation, cont’d

Pre-installation Testing/Troubleshooting

Before mounting the SCP to the wall or furniture, test the system to make sure that the connections are correct and the panel is working correctly. Test the system by powering on the switcher, then pressing the input selection buttons on the SCP and watching the LEDs on the switcher to see if the system switches to the desired inputs.

The connections between the SCP and a System 5 IP equipped with front panel controls can be tested even if input/output devices are not available. For a System 5 IP without front panels controls, input 5 will be the only input available to view.

Mounting the SCP

Once the system has been cabled and tested, the SCP can be mounted to the wall or furniture. See Mounting Options, earlier in this chapter, for a description of the available brackets and boxes in which the SCP may be mounted.

Mounting in a wall box

1.With power removed, insert the SCP into the wall, furniture, or SMB.

2.Secure it to the box or mounting bracket with the provided machine screws. The following illustration shows an SCP mounted in an electrical box.

If you are not installing the SCP into a grounded metal electrical box, make sure that the faceplate is grounded to an earth ground.

							OR
				PROJECT
UME
VOL							HTS		PC
						LIG
				HTS		OFF
			LIG							T
			ON						INPU
						INPU		T	5
			INPU		T		4
	INPU	T	3
										150
	2								S	CP
INPU	T
1

Mounting in a rack

The SCP 150 L is rack-mountable using the full rack width UCM-RAAP mounting plate. Mount the UCM-RAAP using the rack mounting screws included with the monting plate. Next, mount the SCP 150 L to the UCM-RAAP using the SCP’s four mounting screws, as show in the following diagram.

Extron

UCM-RAAP

Extron

SCP 150 L

	150	L
SCP

Ex tro n

Mounting on a lectern

The SCP 150 L is designed to be mounted on a lectern. To mount the SCP 150 L, cut a hole of the required size (see “Preparing the Site” in this chapter) and attach the SCP 150 L using the provided wood screws.

Lectern

Extron

SCP 150 L

R

TO

OJEC

PR

LUME	PC
VO	S
	LIGHT
TS	OFF	150
LIGH	UT
ON	INP5	SCP

INPUT 4

T

INPU3

T INPU 2 UT INP1

2-8 SCP 150 • Installation and Operation SCP 150 • Installation and Operation 2-9