![](/images/new-backgrounds/1170464/17046433x1.webp)
Remote Communication, cont’d
Using the Switch/Function Button Table
Switches are assigned to specific buttons on the SCP, any attached remote control module (IRCM/RCM/ACM), or the IR 402 remote. Each time a button is pressed or released, or a knob is turned on the SCP or a control module, the switch number associated with that button appears on your PC terminal emulator screen (HyperTerminal, etc.) as part of the host response.
On most of the special function SIS commands, the switch number is the X? value that you enter as part of the command.
(See the Command/response table for special function SIS commands, earlier in this chapter.)
The following Switch/Function Button table shows which switch number is associated with each button or knob on the SCP, control module, or IR 402. In the Switch column, locate the switch number displayed on your terminal emulator, then look in the Function Button column beside the number to find out which button was pressed or released.
The SCP does not use all of the available buttons/ switches.
No buttons can be programmed via the SCP.
Switch | Function Button |
1 | Power on |
2 | Power off |
5 | Function 1 (room) button |
6 | Function 2 (room) button |
7 | Function 3 (room) button |
8 | Function 4 (room) button |
9 | Input 1 selection button |
10 | Input 2 selection button |
11 | Input 3 selection button |
12 | Input 4 selection button |
13 | Input 5 selection button |
Switch/Function Button table
Switch number locations
The following illustration shows the button/switch memory block numbering on the SCP 150 front panel. Refer to the Switch/Button table, on the previous page. The switch locations are the same on the SCP 150 AAP and SCP 150 L models.
VOLUME |
| PROJECTOR | ||
|
| Switch | Switch | Switch |
|
| #1 | #2 | #8 |
| IR | Switch | Switch | Switch |
| #5 | #6 | #7 | |
|
| |||
Switch Switch Switch Switch Switch | ||||
#9 | #10 | #11 | #12 | #13 |
|
|
|
| SCP 150 |
SCP 150 • Remote Communication |