Extron electronic SW8/12 VGA, SW12 VGA ARS manual Mounting under a desktop

Installation and Operation, cont’d

Mounting under a desktop

Under-desk mounting requires the optional MBU 149 1U, under-desk mounting kit (part #70-222-01).

Mount an SW8/12 VGA Ars under a desktop as follows:

1.	Install the mounting brackets on the unit’s sides with the eight machine
	screws provided in the kit.
2.	Hold the unit (with brackets attached) against the underside of the desk.
	Mark each bracket's hole location on the underside of the desk.
3.	Drill 1/4" (6.4 mm) deep, 3/32" (2 mm) diameter pilot holes from the
	underside of the desk at the marked hole locations.
4.	Insert the four wood screws into the pilot holes and tighten until
	approximately 1/4" (6.4 mm) of the screw's head is protruding.
5.	Install the mounting brackets, with the unit attached, over the protruding
	screw heads.
6.	Slide the unit slightly to lock it in place.
7.	Tighten all four screws to secure it in place.

Mounting Screws

(2 Plcs)

Each Side

#8 Screw

(4 Plcs)

Each Side

Optional Furniture Mounting Bracket

Figure 2-2 — Mounting the switcher under a desktop

2-4 SW8/12 VGA Ars • Installation and Operation