VNS 104 Software Installation
Before Installing the Software
Before starting the VNS 104 installation, the Enterprise Controller must be updated with compatible firmware
Once the controller has been updated, be certain you have the following items:
From the VNS 104 Software Case | From the Enterprise Controller (EC) | ||
|
|
|
|
• | Device ID | • | EC IP address |
|
|
|
|
• | Device checksum | • | EC port (default = 5432) |
NOTE: The Enterprise Controller may need to be updated with compatible firmware (see
Installing the VNS 104 Software
1.Ensure that the PC running the VNS 104 software is connected to a network.
2.Insert the application disc into the disk drive of the PC.
3.Locate the VNS 104 installation file, VNS 104SetupV1.0.0.15.exe, and
4.The next screen is different depending on whether this is the first installation of the VNS 104 software, an update, a repair attempt, or if you are removing the software.
•If this is the first installation of the VNS 104 software, the following screen appears (see figure 2).
Figure 2. VNS 104 Splash Screen
The splash screen remains for a few seconds, then the installion program begins with step 7.
VNS 104 Multi‑Stream Decoder • Introduction and Installation | 4 |
