Extron electronic user manual 4 - Through-desk mounting, VSW 2VGA A Installation and Operation

3.Attach the through-desk mounting brackets

(MBD 129, part #70-077-02) to the VSW 2VGA A with the four provided machine screws, as shown in the through- desk mounting diagram on the next page.

4.Hold the switcher with attached brackets up against the underside of the desk or table. Use a soft pencil to mark the locations of the holes for the screws that will attach the brackets to the desk.

5.Drill 1/4 inch (6 mm) deep, 3/32 inch (2 mm) diameter pilot holes in the desk or table at the marked screw locations. The holes should be drilled from the underside or inside (concealed side) of the furniture, where the switcher will be located.

6.Attach the switcher to the desk or table with the provided wood screws, as shown in figure 2-4.

AA
2VG	SWV
2T
INPU

1TINPU

2 1

Figure 2-4 — Through-desk mounting

7.To adjust the height of the switcher within the desk, slightly loosen the screws that attach the brackets to the switcher, adjust the height by sliding the switcher up or down, and retighten the screws.

VSW 2VGA A • Installation and Operation 2-7