Extron electronic VSW 2VGA A user manual Installation and Operation, Installation Overview

Installation and Operation

Installation Overview

To install and set up the VSW 2VGA A for operation, follow these steps:

1

Turn all of the equipment off. Make sure that the video and audio sources (computers, stereos, tape decks, or other devices), the VSW 2VGA A, the output devices (projectors, speakers), and the contact closure control device are all turned off and disconnected from the power source.

2

If you are going to daisy chain two or more switchers with VSW I AAP control panels, identify the revision of the VSW 2VGA A board (for configuring the VSW I AAPs) and configure the switchers' jumpers. See “Setting the VSW 2VGA A Jumpers” on page 2-10.

3

4

5

6

7

If desired, mount the switcher. See “Mounting the VSW 2VGA A” in this chapter.

Attach the cables. See “Front Panel Features" and "Rear Panel Features" in this chapter.

Connect power cords and turn on the devices in the following order: output devices, contact closure controller, VSW 2VGA A switcher, and input devices.

Select an input using the front panel input toggle switch or the contact closure controller.

The image should now display, and sound should be audible. If not, ensure that all devices are plugged in and receiving power. Check the cabling and make adjustments as needed. Select a different input to check for a picture and sound.

Mounting the VSW 2VGA A

NIf you are going to daisy chain two or more switchers with VSW I AAP control panels, identify the revision of the VSW 2VGA A board (for configuring the VSW I AAPs) and configure the switchers' jumpers before mounting the switchers. See “Setting the VSW 2VGA A Jumpers” on page 2-10.

The VSW 2VGA A can be mounted in a rack, or under or through furniture, using one of the following optional mounting kits:

•RSF 123 3 inch rack shelf kit (part #60-190-20)

•RSB 123 3 inch rack shelf (part #60-604-20)

2-2 VSW 2VGA A • Installation and Operation