TURNING THE UPS OFF
To turn off the UPS:
While in Normal
NOTE!
DURING SHUT DOWN, DO NOT PRESS ANY BUTTON SINCE UPS MIGHT BE RE- ENERGIZED AND DELIVER POWER TO ITS OUTPUT UNEXPECTEDLY.
6.0 UPS SETUP CONFIGURATION
This section describes how to reconfigure the internal UPS setup options, by entering the CONFIGURATION MODE. The setup parameters includes: UPS output voltage & enable or disable GREEN MODE.
CAUTION
Never change the voltage settings when the UPS is ON and powering any connected loads.
NOTE!
Setting the UPS output voltage to 100 VAC will derate the UPS output VA and WATTAGE ratings. Please refer to the SPECIFICATIONS located at the end of this manual for information on your specific UPS model.
How To Place The UPS Into Setup/CONFIGURATION Mode
To put the UPS into configuration mode, press the “FUNTION/TEST” and “SET/ALARM SILENCE” buttons at same time and hold them for one second. The unit will emit one audible beep and then enter CONFIGURATION MODE.
|
| Note that on the display panel, you will see a single row, 8 |
|
| BIT column located at the bottom of the display. The most |
|
| right bit is function “BIT 0”, the far left is status “BIT 7”. |
|
| Note that there is an illuminated dot “.” in BIT 0 when the |
|
| unit is in CONFIGURATION MODE. |
|
| Pressing the “FUNCTION/TEST” button will move the dot |
|
| from function BIT 0 to function BIT 6. When selecting |
|
| function BIT 0 through BIT 6, observe whether status BIT |
|
| 7 is selected (dot) or deselected (no dot,) for the function |
|
| bit selected. To select (dot) or deselect (no dot) the |
|
| function you are presently in, press the “SET/ALARM |
| BIT 7 | SLIENCE” button to set or deselect function BIT 7. Press |
|
| the “SET/ALARM SLIENCE” and FUNCTION/TEST” |
|
| buttons at same time again and hold for one second. The |
BIT 7 | BIT 0 | alarm buzzer will sound one short beep to acknowledge |
the UPS has stored the settings. |
GREEN MODE (Function BIT 3)
17
