Use & Care Manual
Model COGB ENGLISH
•Do not clean the cooktop while it is still hot. Some cleaners produce noxious fumes when applied to a hot surface.
CAUTION
DO not allow aluminium foil, plastic, paper or cloth to come in contact with o hot burner or grate. Do not allow pans to boil dry.
WARNING
Installation and service must be performed by a qualified installer, service agency or the gas supplier.
WARNING
The California Safe Drinking Water and Toxic Enforcement Act requires the Governor of California to publish a list of substances known to the State of California to cause cancer, birth defects, or other reproductive harm, and requires businesses to warn of potential exposure to such substances.
This product contains a chemical known to the State of California to cause cancer, birth defects, or other reproductive harm.
This appliance can cause
Warnings for Gas and Electric Installation
In case of Propane gas installation
The cooktop is ready for use with natural gas. It may be converted for use with propane gas using the propane conversion kit supplied with the cooktop. Be sure the unit being installed is correct for the type of gas being used.
Refer to the rating plate located on the underside burner box (see installation instruction).
CAUTION
•Always disconnect the electrical plug from the wall receptacle before servicing this unit.
•For personal safety, this appliance must be properly grounded.
•Do not under any circumstances cut or remove the third (ground) prong from the power cord plug.
CAUTION
When connecting the unit to propane gas, make certain the propane tank is equipped with its own high pressure regulator.
In addition, the pressure regulator supplied with the cooktop must be on the inlet gas pipe of this unit.
In case of electrical failure
If for any reason a gas control knob is turned ON and there is no electric power to operate the electronic igniter of the cook top, turn OFF all gas control knobs and wait 5 minutes for the gas to dissipate before lighting the burner manually.
To light the burner manually, carefully hold a lighted match to the burner ports and push and turn the gas control knob to HI until it lights and then turn the knob to desired setting.
5