DELAYED START (ON 500C ONLY)
Allows you to delay shredding for 30, 60 or 90 minutes.
DELAYED START
1 | 2 |
Open drawer and | Close drawer and | Press once for | Press twice for | Press three times for | Press four times to |
add paper | press clock icon on | 30 minute delay | 60 minute delay | 90 minute delay | reset clock |
| control panel | (one LED will | (two LEDs will | (three LEDs will |
|
|
| illuminate) | illuminate) | illuminate) |
|
**To cancel Delayed Start, press and hold Clock icon for 2 seconds
TROUBLESHOOTING
Overheat Indicator: When the Overheat Indicator is illuminated, the shredder has exceeded its maximum operating temperature and needs to cool down. This indicator will remain illuminated and the shredder will not operate for the duration of the recovery time.
Drawer/Bin Door Open: The shredder will not run if the bin is open. When illuminated, close the bin to resume shredding.
#JO'VMM8IFOJMMVNJOBUFEUIFTISFEEFSXBTUFCJOJTGVMMBOEOFFETUPCFFNQUJFE6TF'FMMPXFTXBTUFCBH
Remove Paper: When illuminated, see Paper Jam section under Advanced Product Features.
If a critical situation occurs while SmartLock™ is engaged and the shredder drawer needs to be accessed, follow the steps below.
1 | 2 | 3 |
In case of a power outage, SmartLock™ will remain engaged. Once power is restored, shred cycle will automatically resume.
Locate the access screw on the back of the machine and turn counter clockwise with a 6mm allen wrench.
The service hatch will begin to rise. ,FFQUVSOJOHVOUJM the hatch panel is easily removed from the top of the machine.
To replace the service hatch, position hatch panel back on top of the machine. Hold panel in place while turning the allen wrench clockwise until you feel resistance.
*Shredder will not run if the hatch is not in place. Always replace the hatch to resume shredding.
4
