SafeSense® Technology
Shredder head
Sheet capacity icon 
Paper entry
Indicator lights
Ready (green)
Overheated (red)
Window
ENGLISH
Model MS-460Cs
Card/CD/3.5 disk entry
SafeSense® (yellow)
See safety instructions below
SafeSense® override switch
Active | Not active |
Disconnect power switch
Control switch
Breakthrough Safety Technology! SafeSense® stops shredding when hands are too close to the opening.
— To Test SafeSense® Technology
Press | Touch test area | Sensor lights up |
CAPABILITIES
Will shred: Paper, credit cards, CD/DVDs/3.5 disks and staples
Will not shred: Continuous forms, adhesive labels, transparencies, newspaper, cardboard, paper clips*, laminates or plastic other than noted above
Paper shred size: |
|
2 x 8mm | |
Card/CD shred size: |
|
8mm | |
*Paper clip shredding is not recommended for this shedder. |
|
Sheets per pass | 10* |
Cards/CDs per pass | 1 |
Paper width | 222mm |
Card/CD width | 125mm |
Continuous operation |
|
*A4 (70g) paper at
Fellowes SafeSense® shredders are designed to be operated in home and office environments ranging between 50 – 80 degrees Fahrenheit (10 – 26 degrees Celsius) and 40 – 80% relative humidity.
Maximum: 
IMPORTANT SAFETY INSTRUCTIONS — Read Before Using!
•Keep away from children and pets. Keep hands away from paper entry. Always set to off or unplug when not in use.
•Keep foreign objects – gloves, jewelry, clothing, hair, etc. – away from shredder openings. If object enters top opening, switch to Reverse ( 
) to back out object.
•Never use aerosol products, petroleum based lubricants or other flammable products on or near shredder. Do not use canned air on shredder.
•Do not use if damaged or defective. Do not disassemble shredder.
Do not place near or over heat source or water.
•Operation, maintenance, and service requirements are covered in the instruction manual. Read the entire instruction manual before operating shredders.
•This shredder has a Disconnect Power Switch that must be in the ON (I) position to operate shredder. In case of an emergency move switch to OFF
(O)position. This action will stop shredder immediately.
•Avoid touching exposed cutting blades under shredder head.
•Do not put foreign objects in paper entry.
•Shredder must be plugged into a properly grounded wall outlet or socket of the voltage and amperage designated on the label. The grounded outlet or socket must be installed near the equipment and easily accessible. Energy converters, transformers, or extension cords should not be used with this product.
•FIRE HAZARD – Do NOT shred greeting cards with sound chips or batteries.
2
