a) Copying ring
12.1
12.2
12.3
12.4
–Secure the copying ring (12.1) to the router base by inserting both tenons (12.2) into the recesses (12.3).
–To loosen the copying ring, press both but- tons (12.4) inwards simultaneously.
When choosing the size of the copying ring make sure that the cutter used fits through the ring’s opening.
The distance Y between the workpiece and template is calculated by
–Fit a copying roller in the roller holder and bolt this to the angle arm with the rotating knob (13.4). Make sure that the copying roller and cutter have the same diameter!
–Turn the adjusting wheel (13.3) to adjust the distance between the copying roller and cutter axis.
Accessories, tools
For safety reasons, only use original Festool accessories and tools!
Festool offers a wide range of accessories for the routers, e.g. to make wooden joints or drill rows of holes.
The accessory and tool order number can be found in the Festool catalogue or on the In-
ternet under
Systainer
Many Festool products are shipped in a unique system container, called "Systainer". This pro- vides protection and storage for the tool and accessories. The Systainers are stackable and can be interlocked together. They also can be interlocked atop Festool CT dust extractors.
|
| 14.3 | |
Y = 1/2 (Ø copying ring - Ø cutter) |
| 14.2 | |
|
| ||
b) Copying device |
|
| |
The angle arm |
| 14.1 | |
|
| ||
three copying rollers (13.6), are required for | – | Place one systainer on top of the other. | |
the copying device. | – | Release all four latches on the lower sys- | |
13.1 | |||
| tainer by pulling back at their top edges | ||
|
| ||
|
| (14.1). |
– Slide all four latches upward (14.2).
13.2 | 13.6 | – Snap all four latches back to their flat po- |
sition (14.3) so they engage the stacking | ||
13.3 |
| tabs of the upper systainer. |
|
| |
13.4 |
| Servicing and |
| 13.5 | |
maintenance | ||
|
– Screw the angle arm at the desired height | Any maintenance or repair work | |
in the platen’s threaded bore (13.1) with | ||
that requires opening of the motor or gear | ||
the rotating knob (13.2). | ||
|
11
