FieldServer FS-8700-130 Appendix A.3. Node Status, Appendix A.4. FieldServer Synchronization

FS-8700-130 Notifier NCA2/NFS-3030 Manual Page 18 of 22

System Trouble	Address
LOOP CONTINUITY TEST FAIL LOOP 3	231
LOOP CONTINUITY TEST FAIL LOOP 4	232
LOOP CONTINUITY TEST FAIL LOOP 5	233
LOOP CONTINUITY TEST FAIL LOOP 6	234
LOOP CONTINUITY TEST FAIL LOOP 7	235
LOOP CONTINUITY TEST FAIL LOOP 8	236
LOOP CONTINUITY TEST FAIL LOOP 9	237
LOOP CONTINUITY TEST FAIL LOOP 10	238
AMP FAIL	239
AC FAIL	240
SCB ASSEM. COM. VERIFIED FAILED	241
8255 PORT CHIP CONTROL WORD CHECK FAILE	242
NETWORK COMMUNICATION LINK FAIL PORT A	243
NETWORK COMMUNICATION LINK FAIL PORT B	244
STYLE 4 SHORT A L1	245
STYLE 4 SHORT B L1	246
STYLE 4 SHORT A L2	247
STYLE 4 SHORT B L2	248
STYLE 4 SHORT A L3	249
STYLE 4 SHORT B L3	250
STYLE 4 SHORT A L4	251
STYLE 4 SHORT B L4	252
STYLE 4 SHORT A L5	253
STYLE 4 SHORT B L5	254

System Trouble	Address
WALK TEST - FIRE PROTECTION IS LIMITED	485
REMOTE PROG MODE ACCESSED	486
DIA PROG. CHANGE DET. SERVICE REQUIRED	487
ISIB DATA MESSAGE RECEIVED ERROR	488
ISIB EXECUTIVE ROUTINE RE-ENTERED	489
DIB TO SIB CABLE BAD OR MISSING	490
UPLOAD/DOWNLOAD MESSAGE RECEIVED	491
GLOBAL DATABASE MISMATCH	492
SIB PROG. CHANGE DET. SERVICE REQUIRED	493
HS-NCM SNIFFER MODE ACTIVE	494
EXCEEDED CONNECTION LIMIT	495
NAM CCBE. PROG LOST	496
MEMORY LOSS	497
DVC COMM LOSS	498
A.C. POWER LOSS. BACK UP ACTIVATED	499
BUZZER OFF-LINE	500
PANEL DOOR OPEN	501
OFF NETWORK	502
INSTALL. ERROR	503
OR AUDIO/TELEPHON	504
EXPANDER MODULES	505
MANUAL CONTROL	506
CAT. COMM. FAULT	507
UNKNOWN	508

Appendix A.3. Node Status

•Data for any particular Node is valid while that Node is online and the system is synchronized. Integrity of data for any Node will be lost if the Node goes offline or if synchronism between the FieldServer and the NCA2 Panel is lost.

•Node status offline/online (1/0) is stored in the 502nd address. It is important to read the Node status before reading any information about the Node.

•Node status data integrity itself depends upon system synchronization.

Appendix A.4. FieldServer Synchronization

There is currently no method of auto-synchronizing the FieldServer's Data Arrays with the Notifier NCA2/NFS2- 3030 panel because there is no method for polling the panel through the printer or CRT port. Synchronization of the two devices can be achieved manually pressing the “System Reset” button on the panel while the FieldServer is connected and running. All current events will be re-sent to the FieldServer..

FieldServer Technologies 1991 Tarob Court Milpitas, California 95035 USA Web: www.fieldserver.com

Tel: (408) 262-2299 Fax: (408) 262-2269 Toll Free: (888) 509-1970 email: support@fieldserver.com