FieldServer instruction manual FS-8704-12GE-EGD Manual Column Title Function Legal Values

Models: FS-8704-12

1 26
Download 26 pages 48.5 Kb
Page 9
Image 9

FS-8704-12_GE-EGD Manual

Page 9 of 26

 

 

 

 

 

 

 

Column Title

Function

Legal Values

 

 

The following keywords apply only to the GE-EGD protocol.

 

 

 

 

This identifies the GE device producing the

 

 

 

 

EGD data. Although in decimal dot format, it

 

 

 

 

is not an IP address and does not necessarily

 

 

 

 

correspond to the IP address of the GE-

 

 

 

 

Ethernet port producing the message. It

 

 

 

 

corresponds to the producer ID configured for

 

 

 

 

the CPU producing the data.

Nnn.nnn.nnn.nnn

 

 

 

 

 

 

ge_producerId

The default value is typically the same as the

Where nnn are in the

 

 

 

IP address of the producer but the value can

range 0-255.

 

 

 

be changed and it is possible for one device

 

 

 

 

to have multiple Ethernet interfaces and

 

 

 

 

hence multiple IP addresses.

 

 

 

 

Any change to the producerID must be

 

 

 

 

matched by a similar change in the

 

 

 

 

consumer's configuration.

 

 

 

 

Used with the the producerID, to uniquely

 

 

 

ge_exchangeId

identify a packet of EGD data. Thus, this

Integer values >= 1

 

 

driver uses these two parameters to match a

 

 

 

produced data packet with one or more

 

 

 

 

passive Map Descriptors.

 

 

 

 

Each produced data packet contains raw

Byte, Bit, Word,

 

 

 

packed data. Nothing in the message

 

 

 

Dword, Int , Long

 

 

 

identifies the structure or type of the incoming

 

 

 

Float (4 byte IEEE real

 

 

ge_data_type

data. The Driver therefore cannot

 

 

number) or Double (8

 

 

 

differentiate between byte, integer, real ...

 

 

 

byte IEEE real

 

 

 

numbers and requires the specification of this

 

 

 

number).

 

 

 

keyword to unpack the data buffer.

 

 

 

 

 

 

 

If the producer has been configured to

 

 

 

 

produce data of multiple types in one data

 

 

 

 

packet then you will need multiple Map

 

 

 

 

Descriptors to decode them. The ge_offset is

Zero, Any positive

 

 

ge_offset

used to point to the first byte in the data

 

 

integer

 

 

 

packet to be processed by the Map

 

 

 

 

 

 

 

Descriptor. Typically the Map Descriptor for

 

 

 

 

the 2nd, 3rd ... Map Descriptors associated

 

 

 

 

with one data packet will be non-zero.

 

 

FieldServer Technologies 1991 Tarob Court Milpitas, California 95035 USA Web:www.fieldserver.com Tel: (408) 262-2299 Fax: (408) 262-9042 Toll_Free: 888-509-1970 email: support@fieldserver.com

Page 9
Image 9
FieldServer instruction manual FS-8704-12GE-EGD Manual Column Title Function Legal Values