FieldServer FS-8704-12 instruction manual Appendix B. Error Messages, Message Action

FS-8704-12_GE-EGD Manual Page 22 of 26

Appendix B. Error Messages

Multiple protocol drivers may exist on a FieldServer. Each driver may produce its own error messages and the FieldServer itself may produce error messages.

Message	Action
EGD:#1 Error. Can’t init UDP.	This is a fatal error. The FieldServer needs to be re-initialized
EGD:#2 Error. Can’t get a
	or you need technical support from FieldServer Technologies.
socket.
EGD:#3 Error. Protocol does	The rdbc/rdb/rdbx functions are not supported by this protocol.
not support active polling.	The device you wish to poll must be configured to 'produce' its
Change function for	data and this driver will 'consume' the data using passive Map
mapDesc=<%s>	Descriptors.1
EGD:#4 Error. Producer ID	Each Map Descriptor requires a producerID.1
required for mapDesc=<%s>
EGD:#5 Error. Exchange ID	Each Map Descriptor requires an exchangeID.1
required for mapDesc=<%s>
EGD:#6 FYI. No data type
specified. Defaulted to <Byte>	This is a warning only. You can eliminate the warning by
EGD:#7 FYI. Data type not
	editing the CSV file.1
recognized. Defaulted to
<Byte> for mapDesc=<%s>
EGD:#8 Error. Don't know GE	An illegal data type has been used.1
Data Type(%d) for
mapDesc=<%s>
EGD:#9 Error. Incoming data	An EGD producer has sent a data packet to the FieldServer
	but the driver cannot find a passive Map Descriptor to use to
from ip=<%s>
	process and store the incoming data. It’s possible that the
producerID=<%s>
	producer has been incorrectly configured and that the packet
exchangeID=(%d) is being
	was not intended for the FieldServer. Alternatively, make a
abandoned.
	new Map Descriptor which will handle this data.
EGD:#10 Error. Don't know GE	An illegal data type has been used.1
Data Type (%d) for
mapDesc=<%s>
EGD:#11 FYI. You could have	This message requires no action, but refer to Appendix B.1 of
used a mapDesc called <egd-	this manual to see whether you will benefit from exposing
ii> to expose diagnostic info.	some driver internal diagnostic data.
EGD:#12 Invalid IP. Too many	IP address is more than 15 characters in length.1
characters.
EGD:#13 Invalid IP <%s>	Insufficient points in the IP address. 1
EGD:#14 Error. The mapDesc	Increase the data length parameter for this Map Descriptor
called <egd-stats> is too short	Make sure the Data Array is long enough too.
EGD:#15 FYI. You could have
used a mapDesc called <egd-	Refer to Appendix B.10 \r \h Appendix B.1} for more
stats> to expose diagnostic	information.
info.

1Edit the CSV file, download to the FieldServer and restart the FieldServer for the changes to take effect.

FieldServer Technologies 1991 Tarob Court Milpitas, California 95035 USA Web:www.fieldserver.com Tel: (408) 262-2299 Fax: (408) 262-9042 Toll_Free: 888-509-1970 email: support@fieldserver.com