Page 7 of 34 |
4.SlotServer Installation
The SlotServer plugs directly into the AB1756 ControlLogix rack. Take note of the slot number used for the SlotServer as this will be needed when configuring the I/O in the RSLogix software.
4.1.SlotServer Ports and Displays
Note that there are several hardware ports available on the SlotServer card, but that this SlotServer model only makes use of a select few. The ports and displays of interest are as shown in the diagram below:
Scrolling display shows card messages
Card Status Indicators show general card status
Service Pin for LonWorks Commissioning
Communications Status LED’s show status of communications and card software.
TP/FT10 LonWorks Connection
Ethernet Port. Used for configuration and
Ethernet Protocols.
Scrolling Display
This will Display an OK status when the SlotServer has powered up successfully.
Card Status Indicators:
The Comm and OK lights will indicate green successfully. The Sys indicator will indicate communicating properly; and red otherwise.
when the SlotServer has powered up green if the external nodes are all
Service Pin
To be used for commissioning the SlotServer into a LonWorks network
FieldServer Technologies 1991 Tarob Court Milpitas, California 95035 USA Web:www.fieldServer.com Tel: (408)
