26
Changing pre-set options
Out of balance recovery routine
When your Smart Drive™ is spinning it can sense if the wash load is out of balance and will stop and
Automatic recovery option
Your Smart Drive™ will try to automatically correct the out of balance load. It will fill with water and agitate to redistribute the load before trying to spin up again.
Machine stops option
Your Smart Drive™ will stop, give a short burst of beeps every five seconds, and the RINSE or SPIN light will flash. You must redistribute the load more evenly yourself (use this option if you wish to conserve water).
EXCELLENCE | |
REGULAR | REGULAR |
light on | light off |
= automatic recovery | = machine stops |
PRIDE
REGULAR | REGULAR |
light on | light off |
= automatic recovery | = machine stops |
Fig.31 Adjusting the Out of balance recovery routine
Machine information
Specifications
Model | Capacity | Depth | Width | Height* | Height (lid open) | |
|
|
|
|
|
| |
WA75T65GW1 | 7.5 kg | 650 mm | 650 mm | 1020 – 1050 mm | 1410 – 1440 mm | |
|
|
|
|
|
| |
WA65T60GW1 | 6.5 kg | 600 mm | 600 mm | 1020 – 1050 mm | 1360 – 1390 mm | |
|
|
|
|
|
| |
WA55T56GW1 | 5.5 kg | 560 mm | 560 mm | 1020 – 1050 mm | 1320 – 1350 mm | |
|
|
|
|
|
| |
WA55T56MW1 | 5.5 kg | 560 mm | 560 mm | 1020 – 1050 mm | 1320 – 1350 mm | |
(MW512) | ||||||
|
|
|
|
| ||
|
|
|
|
|
|
Electrical Supply: 220 – 240 V, 50 Hz Sinusoidal, 165 W
Inlet Water Pressure: Max. 1 MPa (150 psi) Min. 34 Pa (5 psi)
Inlet Water Flow Rate: Min. 3 litres/min
Standpipe Height: 850 – 1200 mm
Note: exact height of your Smart Drive™ is dependent on how far the feet are inserted onto the base of the machine.
* Height is measured to the highest point on the console.
4323_NZ_AU_PAC_GW_MW_Washer_UG11.indd 26 | 8/10/09 2:45:27 PM |
