If your Smart Drive™ beeps for help
Your Smart Drive™ is capable of diagnosing its own problems. If your Smart Drive™ gives a musical series of beeps every 5 seconds it is telling you that it has a problem which you can solve using the checklist below.
* The beeps are the same sound your washer makes when you turn it on at the wall.
Musical series of beeps* every 5 seconds and... possible solutions
31
HOT water temperature light is flashing.
Hot water supply is not hot enough to maintain the wash temperature you have selected. Select a lower wash temperature.
Inlet hose filters may be blocked.
There may be a kink in the hose.
Hot tap has not been turned on.
Inlet hoses are connected to the wrong taps.
COLD water temperature light is flashing.
Cold tap has not been turned on.
Inlet hose filters may be blocked.
There may be a kink in the hose.
Inlet hoses are connected to the wrong taps.
Cold water temperature exceeds recommended limits (see ‘Installation instructions’, page 4).
The flow rate of the supply water is too slow.
HOT and COLD water temperature lights are flashing.
The taps have not been turned on.
Inlet hose filters may be blocked.
The hoses may be kinked.
The drain hose is too low or the drain hose is pushed into the standpipe too far and the water is siphoning out of the machine (see ‘Installations instructions’, page 2).
The flow rate of the supply water is too slow.
HIGH water level light is flashing.
The machine is overloaded and can not agitate. Ensure the machine is stationary. Remove items until the remaining ones can move freely.
Select a higher water level.
The first RINSE progress light or SPIN progress light is flashing.
The machine has a suds
4323_NZ_AU_PAC_GW_MW_Washer_UG11.indd 31 | 8/10/09 2:45:28 PM |
