Installation instructions
3
Inlet hoses
1Connect the straight ends of the inlet hoses to the taps. There are washers fitted in both ends.
2Connect the elbow ends of the inlet hoses to the machine inlet valves. Inlet valves are marked on the back of the machine
H=HotC=Cold
3Ensure you have correctly connected hot to hot, and cold to cold.
Tap end | Machine end |
Fig.3 Inlet hose ends
Cold supply only:
If you only have a cold water supply, an inlet valve cap (blanking cap) MUST be connected to the hot inlet valve. The cap prevents water leaking out of the hot valve. The cap is available from your Fisher & Paykel Dealer or Authorised Repairer, Part No. 388491. This appliance incorporates backflow protection complying with AS3500.1. No further backflow protection is required for connection to the water supply.
Levelling
It is IMPORTANT to level the machine to ensure even spin performance.
1Separate the four rubber foot inserts from the moulding and fit into the feet on the base of the machine.
2Move the machine to its final position (we suggest a minimum clearance of 20 mm each side).
3Adjust the feet (wind down) so the machine is level and cannot rock.
Corner cabinets
Adjustable feet
Rubber insert
Fig.4 Adjusting levelling feet
To check if your machine is level:
Look down on the wash bowl and make sure it sits slightly forward of centre. Close the lid. Visually check that the lid fits evenly on both sides (see Fig.5). If not, adjust one of the front feet slightly until it matches. The diagram on the top and bottom are not correct.
Correct
Incorrect
To check levelling look
Wind left foot down (out) to correct
Wind right foot down (out) to correct 
Lid Alignment
Lid
Topdeck 
Lid
Topdeck Lid
Topdeck 
down on the wash bowl
Fig.5 To assess levelling check lid alignment
4Turn on the water and check all hose connections for leaks. Make sure there are no kinks in the hoses.
5Uncoil power cord, remove and discard the plastic pin cover and plug into wall socket.
4323_NZ_AU_PAC_GW_MW_Washer_UG11.indd 3 | 8/10/09 2:45:22 PM |
