4
Installation instructions
Water supply
For best operating conditions your hot water should be approximately 65°C. Your cold water should not exceed 35°C or your hot water exceed 75°C. Temperatures above these may cause the machine to fault or cause damage to the machine. If you have an uncontrolled water heating source (eg a wet back or solar heating system) you should
fit a Safe Valve. This will ensure the hot water temperature remains within safe limits. Inlet water pressure: Max.1 MPa (150 psi) Min. 34 Pa (5 psi)
Inlet water flow rate: Min. 3 litres/min
Minimum height of taps to clear the top of the machine is 1150 mm.
Draining
Regularly check that your standpipe or tub is free from lint or other obstructions, which may affect how your machine works or may cause flooding.
In
Clothes washer safety
This clothes washer is not intended for use by children and persons with reduced physical, sensory or mental capabilities, or lack of experience and knowledge, unless they have been given supervision or instruction concerning use of the appliance by a person responsible for their safety. Your Smart Drive™ can be opened while it is filling and agitating. Supervise children at all times to ensure they do not play with the washer.
WARNING!
Electrical Shock Hazard
If you are using an extension cord or a portable electrical outlet device (eg
Failure to do so may result in death or electrical shock.
Accessories and spare parts
Available from your Fisher & Paykel Dealer or Authorised Repairer.
| Inlet Valve Cap | Part No. 388491 |
|
|
|
|
|
| Hose Inlet Long (2m) | Part No. 422680 | |
|
|
|
|
| Hose Inlet Large Bore | Part No. 426123 | |
|
|
|
|
| Drain Hose Extension | Part No. 425627p | |
|
|
|
|
| Power Cord | If the power cord of your clothes washer is damaged it must be replaced | |
|
| by a Fisher & Paykel Authorised Repairer, as it is not a standard power cord. | |
|
|
|
|
|
|
|
|
4323_NZ_AU_PAC_GW_MW_Washer_UG11.indd 4 | 8/10/09 2:45:22 PM |
