Connecting gas to your dryer
Use compound or thread tape appropriate to the gas type that is to be used (Natural or LP Gas), on the male threads of all
Never use an open flame to test for gas leaks.
This dryer will operate satisfactorily up to altitudes of 6500ft (2000m) above sea level at the BTU rating indicated on the model/serial plate. Burner input adjustments may be required if operating above this elevation.
The dryer must be isolated from the gas supply piping system by closing the supply
Gas ignition
This dryer has an automatic ignition system to ignite the burner. There is no pilot flame burning in this dryer.
Connecting to the gas supply
1.The gas supply line should be 1⁄2 inch.
2.A
3.An ⁄ inch NPT plugged tapping must be installed to allow the gas inlet pressure to be checked.
1/8” NPT plugged tapping
Gas 
1/2” NPT gas supply line 
19
