Fisher & Paykel DishDrawer manual Fault codes, How to Recognize a Fault Code

f a u l t c o d e s

How to Recognize a Fault Code

When a fault has occurred, the will continuously

beep every second.

The fault code will be displayed on the Electronic Display for prefinished and on the inside control panel for integrated models.

Each fault code is shown in the chart below for prefinished and integrated models.

How to Attend to a Fault
Code
1. Press the POWER button to	4. After attending to the fault,		6. When calling your Fisher &
remove the fault code.	turn the	on at the	Paykel Authorized Service Center
	power supply.		advise them of the fault code
2. If the fault code and			that has appeared on the
continuous beeps cannot be	5. If the fault code and		. This information
removed by pressing the POWER	continuous beeps remain, turn		will help the Authorized Service
button, turn the power off at the	the water and power supply off		Center respond better to your
power supply.	to the	.	request.

3. We recommend you check the chart below and correct the fault where possible.

Fault Codes		Possible Causes	What to Do
Prefinished Models	Integrated Models

F1

F2

F3

F4

F9

U1

Flood switch has	Turn the water and power supply to the
been activated.	off and call your Fisher & Paykel Authorized Service
	Center.
Motor problem.	Call your Fisher & Paykel Authorized Service Center.
Temperature sensor	Ensure water coming in through the inlet hose is not
failed.	hotter than 149oF. You may need to install a tempering
	valve on your water supply.
Faulty temperature	Call your Fisher & Paykel Authorized Service Center.
sensor or element
Electronics	Call your Fisher & Paykel Authorized Service Center.
malfunction.
Fill Fault	. Turn the	water supply on.
	. Ensure the spray arm can rotate about the center, and
	if the	is full of water, it will need to be
	emptied manually.

If you have any questions about operating the product, please contact our Fisher & Paykel Customer Care Center.