Fisher & Paykel DD605, DS605 manual Fast Test Cycle, Continuous Cycle Test Mode

599464

3.6Fast Test Cycle

WARNING: Only run this cycle if the DishDrawer™ is connected to the water supply.

This level runs an 8 minute fast test cycle.

Press POWER to skip Fast Test Cycle and advance to the next level. Press START/PAUSE to enter Fast Test cycle.

Once Fast Test Cycle is selected the DishDrawer™ goes into standby mode and 8 minutes will be showing on the display. The test cycle is started by pressing START/PAUSE, and the following components are run during the 8 minute cycle that follows:- Lid motors, fill valve, wash motor, element, drain motor, drying fan.

Press POWER to exit at any time.

3.7Continuous Cycle Test Mode

In this level the DishDrawer™ can be run continuously in any wash cycle. Once the cycle has finished, the DishDrawer™ automatically restarts the same wash cycle.

Press POWER to skip Continuous Cycle. As this is the last level, doing this will exit diagnostics.

Press START/PAUSE to enter Continuous Cycle.

Once selected, the LCD backlight flashes on and off to indicate the DishDrawer™ is in continuous cycle and the cycle starts straight away (for integrated and flat door models the LED above the start/pause button will be orange instead of green to indicate the DishDrawer™ is running in continuous cycle). It will run the last cycle that had been selected prior to going into diagnostics mode.

If it is desired to run a different cycle, exit diagnostics, turn the DishDrawer™ on as normal and select the cycle required. Then turn the DishDrawer™ off again, re-enter diagnostics and restart the Continuous Cycle as above.

Press POWER to Exit at any time.

11