Installation instructions
Fitting the anti-tilt bracket
11
Important! |
|
| |
To restrain the appliance and prevent |
|
| |
it tipping accidentally, the anti- | Dotted line showing the position |
| |
tilt bracket and restraining plate |
| ||
of the cooker when installed |
| ||
supplied must be fitted according to |
|
| |
the instructions below. |
|
| |
1 Drill four 8mm diameter holes for |
| Fig. 4 Attaching the | |
the fixing screws (two in the wall |
| ||
| |||
and two in the |
| ||
sliding the cooker | |||
insert the plastic plugs supplied. | bracket | into place | |
Rear left | |||
Important! |
| ||
foot of cooker |
| ||
|
|
Before drilling the holes, check that you will not damage any pipes or electrical wires.
2 Attach the
3After attaching the
slide the cooker into place. Ensure that the left rear foot slides under the bracket, as shown in Fig.4.
4Access the bracket by removing the drawer
(Fig. 5): | Fig. 5 Accessing the | |
a | Slide out the drawer completely. | by removing the drawer |
b | Press the lever of the left guide rail | Restraining plate |
| down and pull the lever of the right | |
|
| |
| guide rail up. |
|
c | Holding the levers, disengage and |
|
| remove the drawer. |
|
5 If fitted, remove the kickstrip (see ‘Levelling |
| |
the cooker’). Fix the restraining plate by |
| |
sliding it into place and securing it with the | Screw & Washer | |
fixing screw and washer supplied. See Fig. 6. | Fig. 6 Fixing the restraining plate |
6Replace the drawer (Fig. 7):
a Insert the drawer rails into the guide rails.
b Gently push the drawer in completely; the safety catches will automatically hook.
7 Replace the kickstrip using the two screws.
Important!
Beware of sharp edges when removing or replacing the drawer.
Fig. 7 Replacing the drawer