Fisher & Paykel RX616 Installation instructions, Handle removal, Levelling, Tools needed, Steps

8

Installation instructions

Handle removal

Handles are installed at the factory.

Tools needed:

4 mm Allen wrench

To remove:

Remove cap-screw from handle mounting post using 4 mm Allen wrench.

Repeat the procedure on all posts to remove the handle.

To replace:

Align handle with the mounting posts.

Fully tighten all cap-screws to secure handle in place.

Levelling

Caution!

To protect personal property and refrigerator­ from damage, observe the following:

Protect vinyl or other flooring with cardboard, rugs or other protective­ material. Do not use power tools when ­performing levelling procedure.

To enhance the appearance and maintain performance, the refrigerator should be level.

Note:
Complete any required door reversal, panel
installation and/or a water supply connection
before levelling.
Some models only have front levelling adjustment
screws ( a ).	Step 1
Tools needed:
9.5 mm hex head driver
Carpenter’s level

1Remove toe grille.

Grasp firmly and pull outward to unclip.

2Using hex head driver, turn front adjustment screws ( a ) clockwise to raise and counterclockwise

to lower the front of the refrigerator.		Steps 2, 3
3 Select models also have rear adjustment screws ( b ).
Using the hex head driver, turn each of these
adjustment screws ( b ) to raise or lower the rear of the
refrigerator.	a b	b a

Fig.5 Levelling the refrigerator