3Close doors.
4Remove top hinge covers by removing Phillips screws.
5Unscrew 8 mm hex head screws from top hinges.
6Detach main wire connector harness.
Do not remove screw connecting green ground wire.
To detach main wire harness, use a flat blade tool or fingernail to press junction point between two connectors to release.
7Remove top hinges along with doors.
8Remove bottom hinges with a 9.5 mm hex head driver.
Replacing the doors
To replace the doors, follow the steps in door and hinge removal in reverse order.
Important!
If water line tube end is damaged, cut off 16 mm before reconnecting.
RX616 model
1Unplug power cord from power source.
2Remove toe grille (see page 8).
3Unscrew screws from top hinges.
4Remove top hinges along with doors.
5Remove bottom hinges with a 9.5 mm hex head driver.
Replacing the doors
To replace the doors, follow the steps in door and hinge removal in reverse order.
Installation instructions
Step 4
Step 6
Step 7
Step 8
Fig.3 Door and hinge removal (RX693 / RX594 models)
Steps 3 and 4 | Step 5 |
7
Fig.4 Door and hinge removal (RX616 model)
