Then push the waste reducer up through the drain opening. (ILLUSTRATION #6)

If the drain opening on your sink is covered with sealant, remove as much of the putty as possible from the rim of the sink drain hole.

Unless you have a new home, be sure that the existing trap and drain lines are clear. If the drain line is not clear, use a plumber’s rod or auger to remove all impediments.

INSTALL THE SINK MOUNT FLANGE

If a hole needs to be cut in the sink, it should be diameter 87-92mm.

First, place the sink flange rubber gasket over the sink flange’s threaded ring. Insert the flange and rubber gasket in to the sink drain opening from the top side of the sink. It is not necessary to use plumber’s putty when installing the sink flange.

Second, place the sink flange fiber gasket over the sink flange’s threaded ring. Next, attach the mount ring and tighten with one hand while using the other hand to press down on the sink flange. (ILLUSTRATION #7). Hand tighten as tight as possible. Do not try to tighten with a wrench or hammer.

PRESS DOWN FIRMLY WHEN ASSEMBLING

ILLUSTRATION #7

- 5 -

Page 5
Image 5
Fisher & Paykel WD1001 manual Install the Sink Mount Flange, Illustration #7