UNPACKING YOUR WASTE DISPOSAL
Remove the waste disposal from the packing carton, being careful not to misplace any of the pieces. Inside the carton you should find the following: (ILLUSTRATION #2)
1. Sink Drain plug *
2. Sink Frange *
3. Sink Flange Rubber Gasket *
4. Sink Flange Fiber Gasket *
5. Mount Ring *
6. Hinged Clamp *
7. Waste Pipe
8. Flange & Screws
9. Rubber Gasket
10. Hexagon Wrench
ILLUSTRATION #2
If any parts are missing contact your dealer before beginning installation.
REMOVE OLD DISPOSER OR SINK WASTE REDUCER
IF REMOVING AN OLD DISPOSER & INSTALLING A FISHER & PAYKEL WASTE DISPOSAL… Disconnect the drain where it connects to the old disposer’s waste pipe. (ILLUSTRATION #3). Then dismount the disposer from the sink mounting assembly. Finally remove the sink flange from the topside of the sink (ILLUSTRATION #4).
IF REMOVING A SINK WASTE REDUCER
If your sink is equipped with a sink waste reducer instead of a waste disposer, remove the nut or threaded ring holding the waste reducer in place. (ILLUSTRATION #5).
ILLUSTRATION #3
ILLUSTRATION #4
ILLUSTRATION #5
- 4 -
